Installation guide

STEP 1:
Insert the top of the DIN-Rail into the
slot just below the stiff metal spring.
STEP 2:
The DIN-Rail attachment unit will
snap into place as shown below.
To remove MOXA EtherDevice Switch from the DIN-Rail, simply reverse
Steps 1 and 2 above.
Wall Mounting (OPTIONAL)
For some applications, you will find it convenient to mount MOXA
EtherDevice Switch on the wall, as illustrated below.
STEP 1:
Remove the aluminum DIN-Rail attachment plate from MOXA EtherDevice
Switch’s rear panel, and then attach the wall mount plates, as shown in the
diagram below.
⇒
STEP 2:
Mounting MOXA EtherDevice Switch on the wall
requires 4 screws. Use the Switch, with wall mount
plates attached, as a guide to mark the correct locations
of the 4 screws. The heads of the screws should be less
than 6.0 mm in diameter, and the shafts should be less
than 3.5 mm in diameter, as shown in the figure at the
right.
NOTE
Before tightening screws into the wall, make sure
the screw head and shank size are suitable by
inserting the screw into one of the keyhole-
shaped apertures of the Wall Mounting Plates.
Do not screw the screws in all the way—leave about 2
mm to allow room for sliding the wall mount panel
between the wall and the screws.
— 5 —