Installation guide

— 12
—
Auto-Negotiation and Speed Sensing
All of MOXA EtherDevice Switch’s RJ45 Ethernet ports independently
support auto-negotiation for speeds in the 10BaseT and 100BaseTX modes,
with operation according to the IEEE 802.3u standard. This means that some
nodes could be operating at 10 Mbps, while at the same time, other nodes are
operating at 100 Mbps.
Auto-negotiation takes place when an RJ45 cable connection is made, and then
each time a LINK is enabled. MOXA EtherDevice Switch advertises its
capability for using either 10 Mbps or 100 Mbps transmission speeds, with the
device at the other end of the cable expected to similarly advertise. Depending
on what type of device is connected, this will result in agreement to operate at a
speed of either 10 Mbps or 100 Mbps.
If a MOXA EtherDevice Switch RJ45 Ethernet port is connected to a
non-negotiating device, it will default to 10 Mbps speed and half-duplex mode,
as required by the IEEE 802.3u standard.
Specifications
Technology
Standards IEEE802.3, 802.3u, 802.3x
Forward and Filtering
Rate
148810 pps
Packet Buffer Memory 256 KB
Processing Type Store and For-ward, with IEEE802.3x full duplex,
non-blocking flow control
Address Table Size 1K uni-cast addresses
Latency Less than 5 µs
Interface
RJ45 Ports 10/100BaseT(X) auto negotiation speed, F/H duplex
mode, and auto MDI/MDI-X connection
Fiber Ports 100BaseFX ports (SC connector)
LED Indicators Power, Faults, ACT, LNK, 10/100
DIP Switch Port break alarm mask
Alarm Contact One relay output with current carrying capacity of 1A
@ 24 VDC
Optical Fiber
Distance Single mode fiber for 15 km,
Multi mode fiber for 2 km
Wavelength 1310 nm
Min. TX Output -15 dBm (Single), -20 dBm (Multi)
Max. TX Output -6 dBm (Single), -14 dBm (Multi)
Sensitivity -36 to -32 dBm (Single), -34 to -30 dBm (Multi)
Power
Input Voltage 12 to 48 VDC, redundant inputs
Input Current @
24VDC
0.25 A (EDS-305, EDS-305-M, EDS-305-S,
EDS-308)
0.35 A (EDS-308-M, EDS-308-S, EDS-308-MM,
EDS-308-SS)
Connection Removable Terminal Block