Installation guide

— 10
—
LED Indicators
The front panel of MOXA EtherDevice Switch contains several LED indicators.
The function of each LED is described in the table below.
LED Color State Description
On
Power is being supplied to
power input P1
P1 AMBER
Off
Power is not being supplied to
power input P1
On
Power is being supplied to
power input P2
P2 AMBER
Off
Power is not being supplied to
power input P2
On
When the corresponding PORT
alarm is enabled, and the port’s
link is inactive.
Fault RED
Off
When the corresponding PORT
alarm is enabled and the port’s
link is active, or when the
corresponding PORT alarm is
disabled.
On TP port’s 10 Mbps link is active
Blinking
Data is being transmitted at 10
Mbps
10M GREEN
Off
TP Port’s 10 Mbps link is
inactive
On TP port’s 100 Mbps link is active
Blinking
Data is being transmitted at 100
Mbps
100M GREEN
Off 100BaseTX Port’s link is inactive
On FX port’s 100 Mbps is active
Blinking
Data is being transmitted at 100
Mbps
100M GREEN
Off 100BaseFX port is inactive
Auto MDI/MDI-X Connection
The Auto MDI/MDI-X function allows users to connect MOXA EtherDevice
Switch’s 10/100BaseTX ports to any kind of Ethernet device, without paying
attention to the type of Ethernet cable being used for the connection. This
means that you can use either a straight-through cable or cross-over cable to
connect EDS to Ethernet devices.