User`s guide

Industrial Protocols PROFINET I/O
3-3
Configuring PROFINET I/O on Moxa Switches
Enable PROFINET I/O
Enable PROFINET in WEB UI
Type 1
Select the Enable option and click Activate to enable PROFINET I/O. With PROFINET I/O enabled, PROFINET
type LLDP will be enabled automatically.
Select the Disable option and click Activate to disable PROFINET I/O, the switch will disable PROFINET type
LLDP and use standard LLDP.
PROFINET special model is enabled by default on the EDS-400A-PN series switches.
Type 2: New UI 2.0
The default PROFINET I/O setting of EDS E series is disabled. To enable the PROFINET I/O support, check the
Enable PROFINET I/O and click Apply.
NOTE: Enabling PROFINET will prevent MXview (2.2 and earlier versions) from performing auto-detection of
network topology. Auto-detection of network topology is only supported by versions of MXview 2.3 and later.
To use auto-detection in earlier versions of MXview (2.2 and earlier), you should first disable PROFINET I/O,
perform MXview auto-detection of network topology, and then enable PROFINET I/O.
CLI
The CLI (command line interface) can be used to enable or disable PROFINET for the switch.
Command List:
 profinetio to enable PROFINET I/O.
 no profinetio to disable PROFINET I/O.