User`s guide

Industrial Protocols EtherNet/IP
2-26
※
Control Bits
※
Forced interface Speed
Interface Lable
Interface Description
Interface Port Description
Broadcast Storm Protection
※
Interface Utizatiion
Utilization Alarm Upper Threshold
Utilization Alarm Lower Threshold
Port Link Alarm
Port Traffic-Overload Alarm
※
Tx Unicast Packet Rate
※
Rx Unicast Packet Rate
※
Tx Multicast Packet Rate
※
Rx Multicast Packet Rate
※
Tx Broadcast Packet Rate
※
Rx Broadcast Packet Rate
Tx Multicast Packet
Rx Multicast Packet
Tx Broadcast Packet
Rx Broadcast Packet
※
Redundant port status
Port Object (0xf4)
Port Type
Port Number
Link Object
Port Name
Port Type Name
Port Description
Node Address
Port Key
MOXA Networking Object (0x404)
※
Firmware Version
※
System Fault Status
Switch Port Number
※
Port Exist
※
Port Enable
※
Port Link Status
IGMP Snooping Enable
※
Query Interval
※
IGMP Enhanced Mode
Relay1
Relay2
Power 1 relay waring
Power 2 relay waring
DI 1(off) relay warning
DI 1(on) relay warning
DI 2(off) relay warngin
DI 2(on) relay warngin
Turbo Ring Break relay warning
※
CPU usage
Device Up Time
※
Reset MIB Counts
※
Redundant device mode
reset device
I/O message Object
※
Switch Fault Status
※
Port Exist
※
Port Link Status
※
Port Enable
Monitoring AOI Tags
In RSLogix 5000, you can monitor the values of all configured tags by selecting “Monitor Tags” in the
controller organizer window. It can also be used to check that the AOI is installed correctly