User`s guide

Industrial Protocols EtherNet/IP
2-24
Rate
Tx Multicast Packet
DINT
Total number of TX multicast packets
Rx Multicast Packet
DINT
Total number of RX multicast packets
Tx Broadcast Packet
DINT
Total number of TX multicast packets
Rx Broadcast Packet
DINT
Total number of RX broadcast packets
Redundant Port Status
DINT
Bit 0 = Disable,
Bit 1 = Not Redundant port,
Bit 2 = Link down,
Bit 3 = Blocking,
Bit 4 = Learning,
Bit 5 = Forwarding
Tags for Moxa Networking Object
Data Type: MOXA_Vendor_Object_v0
Name
Data Type
Description
System Firmware
Version
DINT
Switch firmware version
System Fault Status
DINT
Switch fault status
Switch Port Number
SINT
Switch max port number
Port Exist
DINT[2]
Switch per port exist
Port Enable
DINT[2]
Switch per port exist
0:Enable
1:Disable
Port Link Status
DINT[2]
Switch per port link status
IGMP Snooping
SINT
IGMP snooping enable:
0: Disable
1: Enable
Query Interval
DINT
Query Interval range from 20~600 sec
IGMP Enhanced Mode
SINT
IGMP enhanced mode
0: Disable (default)
1: Enable
Relay 1
SINT
Override relay warning setting
0: Disable (default)
1: Enable
Relay 2
SINT
Override relay warning setting
0: Disable (default)
1: Enable
Power 1 Relay Warning
SINT
Power input 1 failure (on  off)
0: Disable (default)
1: Enable(relay 1)
2: Enable(relay 2)
Power 2 Relay Warning
SINT
Power input 2 failure (on

off)
0: Disable (default)
1: Enable(relay 1)
2: Enable(relay 2)
DI 1 Off Relay Warning
SINT
DI 1 (off)
0: disable (default)
1: Enable(relay 1)
2: Enable(relay 2)
DI 1 On Relay Warning
SINT
DI 1 (on)
0: Disable (default)
1: Enable(relay 1)
2: Enable(relay 2)
DI 2 Off Relay Warning
SINT
DI 2 (off)
0: Disable (default)
1: Enable(relay 1)
2: Enable(relay 2)
DI 2 On Relay Warning
SINT
DI 2 (on)
0: Disable (default)
1: Enable(relay 1)
2: Enable(relay 2)
Turbo Ring Break Relay
Warning
SINT
Turbo Ring Break (Ring Master Only )
0: Disable (default)
1: Enable (relay 1)
2: Enable (relay 2)
CPU Usage
SINT
Percent of usage (0-100)
Device Up Time
DINT
Number of seconds since device was powered up
Reset Mib Counter
SINT
Reset port MIB counters
Redundant Device Mode
DINT
Bit 0: RSTP,