User`s manual

EDS-828 Series User’s Manual Featured Functions
3-71
There are three action buttons for setting up the IP Interface Table:
Add
To add a entry into the IP Interface Table
Delete
To remove the selected entries from the IP Interface Table
Modify
To modify the content of a selected entry in the IP Interface Table
NOTE
The entries in the IP Interface Table will not be added to the EDS-828’s interface table until you
click the Activate button.
RIP
The RIP page is used to set up the RIP parameters.
RIP Enable
Setting Description Factory Default
Enable/Disable
This option is used to enable or disable the RIP
function globally.
Disabled
RIP Version
You can specify which version the RIP should follow. You can also select V1 Compatibility to
make sure the RIP packet of Version 1 can be received as well.
RIP Distribution
Setting Description Factory Default
Connected
The entries that are learned from the connected ports
will be re-distributed if this option is enabled.
Unchecked
(disabled)
Static
The entries that are set in a static route will be
re-distributed if this option is enabled.
Unchecked
(disabled)