User`s manual

EDS-600 Series User’s Manual Featured Functions
3-38
Coupling Mode
Setting Description Factory Default
Dual Homing
Select this item to change to the
Dual Homing configuration page
Primary Port:
EDS-608: port 2-2
EDS-611: port G1
EDS-616: port 4-2
EDS-619: port G1
Backup Port:
EDS-608: port 2-2
EDS-611: port G1
EDS-616: port 4-2
EDS-619: port G1
Ring Coupling
(backup)
Select this item to change to the
Ring Coupling (backup)
configuration page
EDS-608: port 2-2
EDS-611: port G1
EDS-616: port 4-2
EDS-619: port G1
Ring Coupling
(primary)
Select this item to change to the
Ring Coupling (primary)
configuration page
EDS-608: port 2-2
EDS-611: port G1
EDS-616: port 4-2
EDS-619: port G1
NOTE
The Turbo Ring DIP Switches located on the EDS-600’s
outer casing can be used to configure the EDS’s Turbo
Ring protocols. (For details on how to do this, refer to
“Configuring Basic Settings—Turbo Ring DIP Switch”
section in this manual.)
If you use the web interface, console interface, or Telnet
interface to enable the Turbo Ring DIP Switches, and
then set DIP Switch 4 on the switch’s outer casing to the
“ON” position, you will not be able to use the web
interface, console interface, or Telnet interface to change
the status of the DIP Switch. In this case, the
Communication Redundancy settings will be “grayed
out” in the web browser as shown in the following figure: