User`s manual

EDS-600 Series User’s Manual Featured Functions
3-15
“Turbo Ring V2” DIP Switch Settings
DIP 1 DIP 2 DIP 3 DIP 4
ON: Enables the
default “Ring
Coupling (backup)”
port.
ON
: Enables this EDS
as the Ring Master.
ON: Enables the
default “Ring
Coupling” port.
ON
: Activates DIP
switches 1, 2, 3 to
configure “Turbo Ring
V2” settings.
OFF: Enables the
default “Ring
Coupling (primary)”
port.
OFF
: This EDS will
not be the Ring
Master.
OFF
: Do not use this
EDS as a ring coupler.
OFF: DIP switches 1,
2, 3 will be disabled.
NOTE
The DIP 1 setting will only be active if DIP 3 is in the ON position. If you set DIP 3 to OFF, then
the default Ring Coupling port will NOT be enabled, even if DIP 1 is ON.
Protocol Default Turbo Ring Ports Default Ring Coupling Port(s)
Turbo Ring V2
EDS-608: Port 2-3 and 2-4
EDS-611: Port G2 and G3
EDS-616:Port 4-3 and 4-4
EDS-619: Port G2 and G3
EDS-608: Port 2-2
EDS-611: Port G1
EDS-616: Port 4-2
EDS-619: Port G1
NOTE
The Turbo Ring Ports and Coupling Ports will be added automatically to all VLANs if you set
DIP Switch 4 to the “ON” position.
NOTE
If you do not enable any of the EDS-600 switches to be the Ring Master, the Turbo Ring protocol
will automatically choose the EDS-600 with the smallest MAC address range to be the Ring
Master. If you accidentally enable more than one EDS-600 to be the Ring Master, these EDS-600
switches will auto-negotiate to determine which one will be the Ring Master.
NOTE
If you use the browser interface to enable the DIP switches (by un-checking the “Disable the
Turbo Ring DIP switch” checkbox), and then flip DIP switch 4 from ON to OFF, the Ring Ports
and Coupling Ports that were added to all VLANs will be restored to their previous software
settings. (For details, please refer to the “Using Virtual LANs” section of this manual).