User`s manual

Moxa E Series Managed Ethernet Switch Featured Functions
3-32
Trunk Group (maximum of 4 trunk groups)
Setting Description Factory Default
Trk1, Trk2, Trk3, Trk4
(depends on switching
chip capability; some
Moxa switches only
support 3 trunk
groups)
Specifies the current trunk group. Trk1
Trunk Type
Setting Description Factory Default
Static Selects Moxa’s static trunking protocol. Static
LACP Selects LACP (IEEE 802.3ad, Link Aggregation Control
Protocol).
Static
Trunking Status
The Trunking Status table shows the Trunk Group configuration status.
Link-Swap Fast Recovery
The Link-Swap Fast Recovery function, which is enabled by default, allows the Moxa switch to return to normal
operation extremely quickly after devices are unplugged and then re-plugged into different ports. The recovery
time is on the order of a few milliseconds (compare this with standard commercial switches for which the
recovery time could be on the order of several minutes). To disable the Link-Swap Fast Recovery function, or
to re-enable the function after it has already been disabled, access either the Console utility’s Link-Swap
recovery page, or the Web Browser interface’s Link-Swap fast recovery page, as shown below.
Link-Swap-Fast-Recovery
Setting Description Factory Default
Enable/Disable Checkmark the checkbox to enable the
Link-Swap-Fast-Recovery function
Enable