User`s manual

ioLogik R2140 User’s Manual Using ioAdmin
Server Settings Tab (General)
The Server Settings tab is where you log in as an administrator. This is required in order to gain
access to the ioLogik R2140 configuration options. If no administrator password has been set up,
simply click on Login and leave the Password for entry field blank. Please refer to the ioAdmin
Administrator Functions section later on in this chapter for more detail.
ioAdmin Administrator Functions
For full access to all configuration options, log in as an administrator in the Server Settings tab. This
is required whenever you start up ioAdmin or boot up/restart the ioLogik R2140. When you install
the ioLogik R2140 for the first time, the password will be blank and you may simply click on Login.
Additional functions will available after logging in, including the following new tabs:
When making configuration changes, you will need to click on Update or on Apply to save the
changes. Some changes will not take effect until the ioLogik R2140 is restarted. You will be given
the option to restart the server if necessary.
ATTENTION
You must log in to access administrator functions such as the Watchdog and Firmware Update
tabs. If you forget the password, you may hold down the Reset button on the ioLogik R2140 to
clear the password and load factory defaults. This will result in the loss of all configuration
settings!
3-7