334 Third Edition

Configuring the Network

NPort Server Lite User’s Manual 3-3

3. Press SEL to select NETWORK SETTING, and then press s twice. The LCD screen

should look like:

↑

↓

4. Press SEL again, after which the default IP address will be displayed. Note that the first

digit of the IP address will be highlighted by a blinking cursor, indicating that it can be

edited:

I P A D D R R E S S

↑

1 9 2 . 1 6 8 . 1 2 7 . 2 5 4

↓

The SEL button now acts as the right cursor, the r button decreases the selected digit,

and the s button increases the selected digit.

Keep in mind that there is no left cursor button. If you accidentally press SEL, moving

the blinking cursor to the right before inputting the correct digit, you will need to press

MENU, and then start over at step 3.

You will notice that the displayed numbers are automatically limited to the range

required for IP addresses. For example, the first digit of each of the four numbers can

only be 0, 1, or 2.

5. Use the functions described above to enter the server’s IP address. After changing the

last digit, the blinking cursor will be all the way to the right, highlighting the last digit

of the number.

6. Press SEL to return to the screen shown in step 3. (To change the number, press MENU

and then start over at step 3 above.) To accept the number, press MENU twice, after

which the LCD screen displays

S A V E C H A N G E ?

N O

↓

7. Press SEL to NOT save the setting, or press r to change to the following screen:

S A V E C H A N G E ?

Y E S

↓

8. Press SEL to save the setting. At this point the system will restart, and then return to the

default screen showing the server’s name, serial number, and IP address.