Installation guide

2-5
The next step is to attach the unit to the rail.
STEP 1: The two ends of the bracket
are named A and B. Hook the
A end over the top edge of
the rail.
STEP 2: Push the unit against the rail.
You should hear the B end
clicking into place over the
bottom edge of the rail.
A
B
A
B
To remove the unit from the rail, simply reverse Steps 1 and 2 above. Use your
fingers to pull down on the B end, which should release the bracket from the rail.
Network Connection
There are two ways to use the 10/100BaseT Ethernet jack located on the unit’s
rear panel.
1. For most applications, simply plug one end of your Ethernet cable into the
10/100BaseT jack, and the other end into the hub connected to your network.
In this case, use a standard straight-through Ethernet cable.
2. Use a crossover Ethernet cable when connecting the NPort Server Lite
directly to your computer’s Ethernet port, such as when configuring drivers
and software. A crossover Ethernet cable is included with the NPort Server
Lite.