Installation guide

5-23
Inputting IP Addresses
There are two options to choose from when
inputting IP addresses. The Single Host option is
easy to understand. Simply enter the IP address of
the host that is being granted access to the NPort.
The meaning of the A Group of Host option is a
little bit more complicated. In this case, you must
enter both an IP Address and Netmask. When
written in binary form, the 1-digits in the Netmask
determine that part of the IP address for which all
IP addresses in the Group are the same. For
example, if IP Address = 192.168.100.200 and
Netmask = 255.255.255.0, as shown below, then
any IP address of the form 192.168.100.xxx would be included in the group.