Installation guide

5-11
Figure 3.4 illustrates a
TCP Client Mode
topology that consists of
one NPort connected by a
serial cable to a Card
Reader. The NPort can be
configured so that when
someone swipes their
card, the device server
requests a connection from
the computer, after which
the card’s data is sent over
the Ethernet connection.
Fig. 3.4: TCP Client
Note that the Destination IP address is a required option. This means that the
device can only be set up to request service from one remote networked device.
We should also point out that the Delimiter 1, Delimiter 2, and Force transmit
options are used to activate the optional Data Packing function.
The following figures show the additional parameters that can be configured for
TCP Client Mode. Refer to the table below the figures to see details of the
meaning of each parameter.
Configurator 
 Console Management