Installation guide

3-8
The Configuration window
opens to the Network Settings
page. To modify items, select or
deselect the item by clicking in
the checkbox next to the item.
Click on the OP_Mode, Serial
Settings, Access Control, or
Password tabs to modify the
settings of other parameters.
NOTE Detailed information about these configuration parameters is given in
Chapter 5, Firmware Configuration.
Unlock Server
The Unlock Server function is used to open a password protected NPort so that
the user can modify its configuration. As shown below, six possible states can
appear in the Status column.
The meanings of the six states are as follows (note that the term Fixed is
borrowed from the standard fixed IP address networking terminology):
 Locked
The NPort is password protected, “Broadcast Search” was used to locate it,
and the password has not yet been entered from within the current
Configurator session.
 Unlocked
The NPort is password protected, “Broadcast Search” was used to locate it,
and the password has been entered from within the current Configurator
session. Henceforth during this Configurator session, activating various
utilities for this NPort will not require re-entering the server password.