Operating instructions

16 BAL SX302 ETH EN 3.1
Chapter 5 Configuration
MAC address The MAC address of the unit is to be found on the Ethernet coupling of the control
processor (see label). It is possibly needed for commissioning and should be
written down on page 2 of this operating manual before the unit is mounted on a
hardly accessible location.
Basic configuration The basic configuration can be set up without external aids via the menu (see
chapter 4). To integrate the unit in the network, either DHCP must be activated, or
the static IP address, the relevant Subnet Mask and, if necessary, the IP address
of the standard gateway must be set. These values are assigned by the system
administrator and should be known before putting the unit into operation.
Configuration via network As soon as the units can accessed via TCP/IP, additional configuration can take
place via Telnet and HTTP. Access can be password-protected or can be
deactivated, to prevent unauthorized operations. As-delivered and after setting the
default in menu item U, access is enabled.
Additional information The configuration dialogs are self-explanatory. For detailed information, please
refer to the documentation of the Ethernet coupling (Moxa NE4100T type). For
further information and PC tools, please go to www.moxa.com.
Basic setting Via Telnet and HTTP the gateway can inadvertently be parameterized so that it is
no longer accessible via the network. In this case the gateway can be rest in a
defined status via menu and selection of default in menu item U (see chapter 4)
and after resetting of the network parameters it can be accessed via network
again.