User`s manual

DA-710 Series Hardware Manual Hardware Installation
2-18
Note: The DA-710 computer has been pre-installed with a ready-to-run operating system
(either Linux or Windows Embedded Standard 2009) in the DOM. If the DOM has been removed,
you must install the operating system in another hard disk.
ATTENTION
A
SATA hard disk cable and SATA power cable and hard disk bracket and the HD bracket
are not included in
the
basic package of the DA-710 embedded computer. Any standard SATA disk and power cable can be used
.
Inserting and Removing Expansion Modules
The DA-710 embedded computer has four expansion slots for inserting expansion modules. Expansion modules
can be installed in Slot A, B, C, or D. To insert or remove expansion modules, follow these instructions.
1. Disconnect the DA-710 from the power source.
2. Unscrew expansion module A, B, C or D on the rear panel.
3. Carefully insert or remove the expansion module by pushing or pulling on the two screws at the same time.
By pushing or pulling on the two screws evenly, you can ensure that the board is inserted or removed
without being damaged.