User`s manual

DA-710 Series Hardware Manual Hardware Installation
2-17
4. Install the SATA hard disk in the hard disk bracket. One bracket can hold up to 2 hard disks; you may use
either the upper or lower layer on the bracket to install the hard disk. Fasten the two screws on each side
of the bracket.
5. Next, install the SATA hard disk and hard disk bracket back into the DA-710.Connect the SATA disk cable
and power cable to the SATA hard disk. The DA-710 also offers an IDE connector that can be used to
connect to an IDE-based hard disk. However, the IDE connector is being occupied by the DOM. To install an
IDE hard disk, remove the DOM first, and then install the hard disk. When finished, connect the disk cable
to the IDE connector.