User`s manual

DA-710 Series Hardware Manual Hardware Installation
2-16
ATTENTION
M
ake sure you orient the CompactFlash card in the right direction.
ATTENTION
The DA
-710 embedded computer does not support the CompactFlash hot swap and PnP (Plug and Play)
function
s. You must disconnect the power source before inserting or removing the CompactFlash card.
Installing a SATA Hard Disk
The DA-710 embedded computer has two SATA connectors for installing two SATA hard disks. To install a
2.5-inch SATA hard disk, follow these instructions.
1. Disconnect the DA-710 from its power source.
2. Open the top cover of the DA-710. A hard disk bracket is located on the left side of the DA-710.
3. Remove the four screws on each corner and remove the hard disk bracket.