User`s manual

DA-710 Series Hardware Manual Hardware Installation
2-14
Pin 10/100 Mbps 1000 Mbps
1 ETx+ TRD(0)+
2 ETx- TRD(0)-
3 ERx+ TRD(1)+
4 --- TRD(2)+
5 --- TRD(2)-
6 ERx- TRD(1)-
7 --- TRD(3)+
8 --- TRD(3)-
LED Color Description
Gigabit RJ45
Connector
Green 100 Mbps Ethernet mode
Orange 1000 Mbps (Gigabit) Ethernet mode
Off Not operating or 10 Mbps Ethernet mode
The default IP addresses and netmasks of the Gigabit LAN ports are as follows:
Default IP Address
Netmask
LAN 1 192.168.3.127 255.255.255.0
LAN 2 192.168.4.127 255.255.255.0
LAN 3 192.168.5.127 255.255.255.0
LAN 4 192.168.6.127 255.255.255.0
Upgrading the Memory Module
The DA-710 embedded computer supports one 200-pin DDR2 533 SODIMM module, of up to 2 GB. A 1-GB
DDR2 SDRAM memory module is factory-installed. To upgrade the DDR2 SDRAM memory module, follow these
instructions:
1. Disconnect the DA-710 from the power source. Make sure all the expansion modules have been removed.
2. The DA-710’s memory module is located inside the DA-710, just below the expansion modules. Unscrew
the top cover of the DA-710.
3. There are two clutches on both sides of the module. Click the clutches, and the memory module will pop up.
Gently remove the module.