User`s manual

DA-710 Series Hardware Manual Hardware Installation
2-9
Reset Button
Pressing the Reset button initiates a hardware warm reboot. This button is comparable to a desktop PC’s reset
button. After pressing the reset button, the system will reboot automatically. During normal use, you should
NOT use the Reset Button. You should only use this button if the software is not working properly. To protect
the integrity of data being transmitted or processed, you should always reset the system from the operating
system with the software reboot function.
Front Panel LED
There are 76 LED indicators on the front panel. Information about each LED is given in the following table.
LED Color Description
Power Green Power is on.
Off No power input or power error.
Storage Orange/Blinking Data is being written to or to read from the storage unit.
Off The storage unit is idle.
Gigabit LAN LEDs
1-4
Green 100 Mbps Ethernet mode.
Orange 1000 Mbps (Gigabit) Ethernet mode.
Off No activity or 10 Mbps Ethernet mode.
Module A/B/C/D
1-8
Green Serial port’s Tx signal, or 100 Mbps Ethernet mode is active.
Orange
Serial port’s Rx signal, or 10 Mbps Ethernet mode is active.
Off No activity.
Power Fail 1-2 Red Power input 1 or 2 has failed.
Off Power inputs are normal.
Programmable Orange Customer defined.