User`s manual

DA-710 Series Linux Managing Communications
3-23
6. If you use LAN1 to connect to the ADSL modem, add file /etc/ppp/options.eth0. If you use LAN2 to
connect to the ADSL modem, then add /etc/ppp/options.eth1, etc.
name [e-mail]
mtu 1492
mru 1492
defaultroute
noipdefault
~
~
"/etc/ppp/options.eth0" 5 lines, 67 characters
Type your username (the one you set in the /etc/ppp/pap-secrets and /etc/ppp/chap-secrets files)
after the name option. You may add other options as desired.
7. Set up DNS.
If you are using DNS servers supplied by your ISP, edit the file /etc/resolv.conf by adding the following
lines of code:
nameserver ip_addr_of_first_dns_server
nameserver ip_addr_of_second_dns_server
For example:
nameserver 168.95.1.1
nameserver 139.175.10.20
MOXA:/etc# cat resolv.conf
#
# resolv.conf This file is the resolver configuration file
# See resolver(5).
#
#nameserver 192.168.1.16
nameserver 168.95.1.1
nameserver 139.175.10.20
nameserver 140.115.1.31
nameserver 140.115.236.10
MOXA:/etc#
8. Use the following command to create a pppoe connection:
#pppd eth0
The ADSL modem is connected to the LAN1 port, which is named eth0. If the ADSL modem is connected
to LAN2, use eth1, etc.
9. Type #ifconfig ppp0 to check if the connection is OK. If the connection is OK, you should see the IP
address of ppp0. Use #ping to test the IP address.
ppp0 Link encap Point-to-Point Protocol
inet addr 192.76.32.3 P-t-P 129.67.1.165 Mask 255.255.255.0
UP POINTOPOINT RUNNING MTU 1500 Metric 1
RX packets 33 errors 0 dropped 0 overrun 0
TX packets 42 errors 0 dropped 0 overrun 0
10. If you want to disconnect it, use the kill command to kill the pppd process.