User`s manual

DA-710 Series HW User’s Manual Hardware Installation
ATTENTION
A SATA hard disk cable and SATA power cable and hard disk bracket and the HD bracket are
not included in the basic package of the DA-710 embedded computer. Any standard SATA disk
and power cable can be used.
Inserting and Removing Expansion Modules
The DA-710 embedded computer has four expansion slots for inserting expansion modules.
Expansion modules can be installed in Slot A, B, C, or D. To insert or remove expansion modules,
follow these instructions.
1. Disconnect the DA-710 from the power source.
2. Unscrew expansion module A, B, C or D on the rear panel.
3. Carefully insert or remove the expansion module by pushing or pulling on the two screws at
the same time. By pushing or pulling on the two screws evenly, you can ensure that the board
is inserted or removed without being damaged.
2-22