User`s manual

DA-710 Series HW User’s Manual Hardware Installation
4. Install the SATA hard disk in the hard disk bracket. One bracket can hold up to 2 hard disks;
you may use either the upper or lower layer on the bracket to install the hard disk. Fasten the
two screws on each side of the bracket.
Next, install the SATA hard disk and hard disk bracket back into the DA-710.Connect the
SATA disk cable and power cable to the SATA hard disk. The DA-710 also offers an IDE
connector that can be used to connect to an IDE-based hard disk. However, the IDE connector
is being occupied by the DOM. To install an IDE hard disk, remove the DOM first, and then
install the hard disk. When finished, connect the disk cable to the IDE connector.
Note: The DA-710 computer has been pre-installed with a ready-to-run operating system
(either Linux or Windows Embedded Standard 2009) in the DOM. If the DOM has been
removed, you must install the operating system in another hard disk.
2-21