User`s manual

DA-710 Series HW User’s Manual Hardware Installation
3. There are two clutches on both sides of the module. Click the clutches, and the memory
module will pop up. Gently remove the module.
4. Carefully slide the module into the clutch at an angle, and then push downward. Make sure the
module has been firmly inserted and is oriented correctly.
Installing a CompactFlash Card
The DA-710 embedded computer comes with a CompactFlash socket. To insert a CompactFlash
card, follow these instructions.
1. Disconnect the DA-710 from its power source.
2. Unscrew the cover of the DA-710. The CompactFlash socket is located in the middle of the
main board, just below the DOM socket. See the following figure for details.
2-18