User`s manual

DA-710 Series HW User’s Manual Hardware Installation
HIPOT (Dielectric Strength) Testing
Before performing the HIPOT test, you MUST have the jumpers removed and the braided ground
cable disconnected. This is required to prevent the transient/surge suppression circuitry, which is
connected to Surge Ground, from being activated during the HIPOT test.
Reset Button
Pressing the Reset button initiates a hardware warm reboot. This button is comparable to a desktop
PC’s reset button. After pressing the reset button, the system will reboot automatically. During
normal use, you should NOT use the Reset Button. You should only use this button if the software
is not working properly. To protect the integrity of data being transmitted or processed, you should
always reset the system from the operating system with the software reboot function.
Reset
Button
2-10