User`s manual

DA-710 Series HW User’s Manual Hardware Installation
Connecting the Power
To power on the DA-710 embedded computer, connect the power line to the DA-710’s AC power
connector (located on the right side of the rear panel) using the power cord and then press the
power button. The DA-710 offers dual power inputs for redundancy. See the following figure for
detailed power cable wiring.
PWR 1 PWR 2
+
L
+
L
N
N
NC
NC
Chasis Ground
Surge Ground
Power 1
Power 2
+
L
N
+
L
N
Surge Ground
Chasis Ground
Power
Switch
Power Input 2
Power Input 1
If the power is being properly supplied, the Power LED will light up first, and then the Storage
LED will start blinking when the Flash Disk Module is accessed during boot up. It takes about 30
to 60 seconds for the operating system to boot up. If Power 1 or Power 2 is not functioning, the
Power 1/2 Fail LED will light up. If this happens, check the power inputs.
Power/Storage
LED Indicators
Power 1/2 Fail
LED Indicators
2-6