User`s manual
PCI Express Board User's Manual Driver Installation: Windows Vista/2008
3-53
SCO
• SCO OpenServer 5
• SCO OpenServer 6
• SCO UnixWare 7
Follow the steps given in this section to install the SCO OpenServer 5/6 & SCO UnixWare 7 driver. The
installation procedures for SCO UnixWare 7 and SCO OpenServer 5/6 are similar.
1. Copy the driver file .tar to your host.
2. #tar xvf <driver tar file>
#/tmp/moxa/mxinstall
3. The window shown below will open next. Press RETURN to continue.
=============================================================
Copyright© 2008 Moxa Inc.
All Rights Reserved.
Moxa Smartio/Industio Family Device Driver Installation (Ver. 1.11)
=============================================================
For SCO UnixWare 7
Tar files, please wait.....O.K.
Press RETURN to continue
NOTE
If your environment is SCO
OpenServer 5/6, you could skip step 4 & 5
4. When you see the screen below, select “Esc” to exit and reboot your computer.
MOXA Smartio/Industio Family Installation Utility (Ver 1.11)
Smartio/Industio Family Basic Configuration
Board No.
Board Type
I/O Address
Interrupt
Bus/Dev No.
1
None
------------
------------
------------
2
None
------------
------------
------------
3
None
------------
------------
------------
4
None
------------
------------
------------
PgDn: getty Setting
Enter: Confirm Input Value
Esc: Exit
Tab: Change Item
5. After rebooting computer, key in “moxaadm”, you will see MAIN MENU, select Basic Configuration.
MAIN MENU
Basic Configuration
Advanced Configuration
Interface Configuration
Port Monitoring
Terminal Emulation
Driver Removal
Exit