User`s manual

CA Series User’s Manual Software Installation
3-40
Select Auto Enumerating COM Number to map subsequent ports in numerical order. For
example, if COM 3 is assigned to Port 1, then COM 4 will be automatically assigned to Port 2.
3. Select an Rx FIFO Trigger. The default value is 56 bytes (high level). Select Set the change
to all ports to use this setting for all serial ports on the module.
4. Select a Tx FIFO Size. The default value is 64 bytes (high level). Select Set the change to all
ports to use this setting for all serial ports on the module.
5. Click OK to approve the port settings. Click OK again to close the CA Series Properties
window and apply the new port settings.
Using PComm
PComm Diagnostic is a useful program for checking the module’s status. It provides internal and
external testing of IRQ, TxD/RxD, UART, CTS/RTS, DTR/DSR, and other items. You can use
PComm Diagnostic to verify that the module and serial ports are working properly.
The free version of PComm is available at Moxa’s website (www.moxa.com).
Using Event Log
You may refer to the Windows event log to verify operation of the module. To view the event log,
open Event Viewer, which is located under Administrative Tools in the Control Panel. Information
about the module will be located under the System category.