User`s manual

CP-132 Series Software Installation
3-8
First Time Driver Installation Stage
This stage presents the steps for installing the driver for the first time of the first Industio CP-132 Series board.
The installation of the Industio CP-132 Series board for Windows 95 and Windows 98 are slightly different and
will be described in two columns. Follow the steps in the left column for Windows 95 or the right column for
Windows 98 respectively.
If one MOXA CP-132 Series board had been previously installed and another MOXA CP-132 Series board was
plugged, the system will prompt you to do Port Configuration Stage discussed in the next section and skips
this stage.
Upon detecting the first new Industio CP-132 Series board, Windows 95/98 will automatically display a New
hardware found message box, and then pop up the following dialog boxes. Click Next button.
Windows 95
1. Click [Next] button.
Windows 98
1. Click [Next] button.
2. 2. Click [Other Locations] button. 2. Select [Display a list...] and click [Next] button.
3. Type A:\Windows.95 in the Location field,
and click [OK] button in Select Other
Location dialog box. The system will start
reading the files from the diskette.
3. Select Other Devices and click [Next] button.