User`s manual

CP-132 Series Software Installation
3-3
6. Click [Add] button to open Property dialog box to change port setting and advanced FIFO configuration
done automatically by the system.
7. Select the newly plugged Industio CP-132 Series board from the b pull down list.
8. In the “Property” dialog box, select the desired port in the port list and click [Port Setting] to enter the
individual “Port #” setting dialog box to change the port COM number mappings or FIFO settings.
• Port Number
You have to set up all the ports of the board with the desired “COM number”, which should not conflict
with other COM number in use. In this “Individual Port Setting” dialog box, you may have two ways to
map the physical ports to COM numbers depending on the check box “Auto Enumerating COM
Number”.