User`s manual

Smartio C104H/HS User’s Manual 2-1
2
2
2 Hardware Installation
The installation of the Smartio C104 Series consists of hardware and software
installation. The hardware installation is detailed in this chapter. The next chapter
deals with the software installation for various operating systems.
Default Settings
The Smartio C104 Series has the following default (factory) settings:
I/O address:
0x180 (Port 1), 0x188 (Port 2), 0x190 (Port 3), 0x198 (Port 4)
IRQ: 10
INT Vector: 0x1C0
CAP Jumper JP1: Open
Note ! If the default settings above are what you desire and good for the
system without conflicts, you may simply install the board in the
system and go directly to the next chapter, “Software Installation”.
Otherwise, follow the instructions below.
JP1
Smartio C104 Series