User`s manual

Software Installation l l Chapter 3

2. Select “MOXA Smartio/Industio PCI Series Adapter” in “Network Adapters”.

3. Click on the [Properties] button to open the “Smartio/Industio PCI Series Boards

Configuration” dialog box. Please see steps 6-10 in the previous section, “Installing

Driver”, for more details.

3.1.3 Adding/Removing the Board

Following is the procedure to add/remove Smartio C104 PCI Series boards after a first

time installation. Note that the presence of the board(s) is(are) required for

adding/removing boards.

1. Power off the system.

2. Plug/unplug the boards in the system.

3. Power on the system.

4. Run the software configuration to setup the boards, as shown in the previous section.