User`s manual

Chapter 3 l l Software Installation

10. Once the system restarts, you may check the event log issued by the MOXA driver to

see if the ports of the board are initialized successfully.

l Enter the [Administrative] group, click on the [Event Viewer] icon and

select [Log] and [System] to check a message similar to “MOXA C104 PCI,

with serial ports COM3 to COM6, has been enabled” for each configured

board.

l If an error message similar to “Cannot find any configured MOXA C104

PCI board!” appears, refer to the “Troubleshooting” chapter for solutions.

Note ! Once the board and the driver are installed and the driver restarts

successfully, you can start to develop applications with the PComm library

(See “Serial Programming Tools”) or the Microsoft Win32 API. You can

also execute any ready-made applications, such as PComm utility Terminal

emulator (See “Serial Programming Tools”) or HyperTerminal to

transmit/receive data, as well as Remote Access Service to provide dial-up

networking capabilities.

3.1.2 Configuring the Port

If you already have installed the driver and want to re-configure the ports, please follow

this procedure.

1. In the [Control Panel], click on the [Network] icon and select the [Adapters] tab.