User`s manual

Software Installation l l Chapter 3
11
In the “Advanced Setting” dialog box, you may customize the driver with the
following two features:
l Rx FIFO trigger level
Rx FIFO trigger levels, at 1, 4, 8 or 14 bytes, are available, and the default
value is 14 bytes.
l Tx FIFO size
Tx FIFO sizes from 1 to 16 bytes are available, and the default value is 16
bytes.
7. Click [OK] on all the dialog boxes to finish the configuration and exit the “MOXA
Configuration Panel” dialog box.
8. When the configuration is done, click [OK] in the “Network” dialog box.
9. Restart Windows NT. The latest configuration will not take effect unless the system
restarts.
Note! Double check if all the Smartio C104 PCI Series components – the
control board and the external 1X4 cable – are connected and fastened
tightly to make sure that the system and the driver start successfully.