User`s manual

Chapter 3 l l Software Installation
10
Click [Properties] to bring up the “Port Setting” dialog box to setup the selected
board with the correct “COM Number”.
è
In this panel, you may:
l Click [OK] to confirm the configuration changes you made.
l Click [Cancel] to leave the dialog box with the configuration unchanged.
In the “Port Setting” dialog box, you may click on the [Advanced] button to
configure the “Rx FIFO trigger level” and “Tx FIFO size” advanced features,
for each port, for particular performance requirements.
Note ! You may skip the following settings and go directly to Step 7 if you do
not require any particular performance tuning for the driver.