Network Hardware User Manual

MOXA AirWorks AWK-1100 User’s Manual Web Console Configuration
3-2
Overview
Menu Structure
The left side of the home page contains a menu that you can use to carry out commands. Here is a
brief description of the hyperlinks in the menu:
y Home. For returning to the home page.
y Status. Status information.
¾ Wireless Clients. The status of the wireless clients currently associated with the AP.
¾ DHCP Mappings. Current IP-MAC address mappings of the built-in DHCP server.
¾ System Log. System events log.
¾ Link Monitor. When the AWK-1100 is in AP Client mode, this page shows the signal
strength and link quality of the wireless link to its associated access point.
y General. Global operations.
¾ Operational Mode. Operational mode of the AWK-1100—AP/Bridge or AP Client.
¾ Password. For gaining rights to change the settings of the AWK-1100.
¾ Firmware Tools. For upgrading the firmware of the AWK-1100, backing up and
restoring the configuration, and resetting the AWK-1100’s configuration to factory
defaults.
y TCP/IP. TCP/IP-related settings.
¾ Addressing. IP address settings for the AP to work with TCP/IP.
¾ DHCP Server. Settings for the DHCP (Dynamic Host Configuration Protocol) server on
the Access Point.
y IEEE 802.11. IEEE 802.11g-related settings.
¾ Communication. Basic settings for the IEEE 802.11g interface of the AWK-1100 to
work properly with wireless clients.
¾ Security. Security settings for authenticating wireless users and encrypting wireless data.
¾ IEEE 802.1X/RADIUS. IEEE 802.1X Port-Based Network Access Control and RADIUS
(Remote Authentication Dial-In User Service) settings for better wireless security.