User`s manual

NPort 6000 Series User’s Manual Module Settings
6-15
Option Description
Local
Verify the ID against the NPort 6000 User Table.
RADIUS
Verify the ID against the external RADIUS server.
RADIUS - Local
Radius authentication is tried first, switching to Local if unsuccessful.
Local - RADIUS
Authentication is performed locally first, switching to Radius if
unsuccessful
TACACS+
Verify the ID against the external TACACS+ server.
TACACS+ - Local
TACACS+ authentication is tried first, switching to Local if
unsuccessful.
Local - TACACS+
Authentication is performed locally first, switching to Radius if
unsuccessful
None
Authentication is not required.
Try next type on authentication denied (default=Disable): The field enables or disables the
system to try next type on first authentication denied.
Phone number: Use this field to configure the number that the user uses to dial out.
Initial string: Use this field to configure the initial string that the modem will use to establish the
connection.
Connection control
Connection control Connect Rule Disconnect Rule Modem
Always on/None Always on after power on None
Trunk
Periodically
connect/inactivity time
Periodically re-connect (based on
the connection interval setting) to
Modem after power on.
Inactivity time is up
Trunk
Remote host fail/remote
host recovered
Remote Ethernet host has failed.
The NPort 6000 will check the
remote host connection on the
Ethernet side after power on.
Once a connection failure has
occurred, data from the serial
device will be sent out through
the Modem.
When the remote
Ethernet host returns to
normal, data will revert to
being sent over Ethernet.
Backup