User`s manual

NPort 6000 Series User’s Manual Configuration with the Web Console
5-5
Opening the Web Console
Open your web browser and enter 192.168.127.254 in the website address line. This is the default
IP address for the NPort 6000–if a new address has been assigned, enter the new address instead.
Press ENTER to load the page.
ATTENTION
The examples and figures in this chapter use the NPort 6000 factory default IP address of
192.168.127.254. If you have assigned a different IP address to your NPort 6000, be sure to adjust
accordingly when following these directions. Please refer to
Chapter 3, Initial IP Address
Configuration, for details on how to configure the IP address.
Only one user can log into the Web Console at a time. If the user is idle 5 minutes after logging in,
then the user will be logged out automatically by the system. The default login username is Admin
with no password. Note that only the user admin can upgrade the firmware.
ATTENTION
If you find the“Login Error” and “Already Login” in your web browser, it means the user still
login now or you forgot logout when you close the browser. If you forgot to logout, please wait 5
minutes or restart NPort.
If you forget your password, the ONLY way to configure the NPort 6000 is by using the reset
button to reset all settings and load the factory defaults. If you have disabled the reset button in
your NPort 6000 configuration, you may still use it to load the factory defaults within the first 60
seconds that the NPort 6000 is powered on.
Remember to back up your configuration by exporting it to a file. Your configuration can be
easily restored by importing the file to the NPort 6000. This will save time if you have forgotten
the password and need to reload the factory defaults.