User`s manual

NPort 6000 Series User’s Manual System Management Settings
9-10
6000 will automatically send a warning to the administrator as configured on the Serial Event
Settings page.
For the NPort 6450 and 6650, after the relay output status has been changed, administrators may
reset its status by selecting Acknowledge Event from the NPort 6000 console, or by correcting the
DSR signal. Please refer to the section on System Monitoring later in this chapter for more
information.
ATTENTION
SNMP indicates a change in DCD or DSR signals but does not differentiate between the two. A
change in either signal from “–” to “+” is indicated by “link up” and a change in either signal
from “+” to “–” is indicated by “link down.”
E-mail Alert
The E-mail Alert settings configure how e-mail warnings are sent for system and serial port events.
You may configure up to 4 e-mail addresses to receive automatic warnings.