User`s manual

NPort 6000 Series User’s Manual Additional Serial Port Settings
8-2
Port Communication Parameters
Port alias: This optional field allows you to assign an alias to a port for easier identification.
Serial Parameters
ATTENTION
The serial parameters for the each serial port on the NPort 6000 should match the parameters used
by the connected serial device. You may need to refer to your serial device’s user’s manual to
determine the appropriate serial communication parameters.
Baud rate (default=115200 bps): This field configures the port’s baudrate. Select one of the
standard baudrates from the dropdown box, or select Other and then type the desired baudrate in
the input box.
ATTENTION
If the port requires a special baudrate that is not listed, such as 500000 bps, you may can select
the Other option and enter the desired baudrate into the text box. The NPort 6000 will
automatically calculate the closest supported baudrate. The margin for error will be less than
1.7% for all baudrates under 921600 bps.
Data bits (default=8): This field configures the data bits parameter. Note: If data bits is set to 5
bits, stop bits will automatically be set to 2 bits.
Stop bits (default=1): This field configures the stop bits parameter. Note: If data bits is set to 5 bits,
stop bits will automatically be set to 1.5 bits.
Parity (default=None): This field configures the parity parameter.
Flow control (default=RTS/CTS): This field configures the flow control type.
FIFO (default=Enable): This field enables or disables the 128-byte FIFO buffer. The NPort 6000
provides FIFO buffers for each serial port, for both the Tx and Rx signals. Note, however, that you