User`s manual

NPort 6000 Series User’s Manual Configuring Serial Port Operation Modes
7-34
TCP/IP compression (default=No): The setting of this field depends on whether the remote user’s
application requests compression.
Inactivity time (default=0 ms): This field specifies the idle time setting for auto-disconnection. A
setting of 0 ms will cause the port to remain connected even if idle.
Link quality report (default=No): Setting this field to Yes allows the NPort 6000 to disconnect a
connection if the link noise exceeds a certain threshold.
Username: This is the dial-out user ID account.
Password: This is the dial-out user password.
Authentication type (default=None): This field allows you to configure the method used, if any,
to verify a user’s ID and authorization.
Option Description
Local
Verify the ID against the NPort 6000 User Table.
RADIUS
Verify the ID against the external RADIUS server.
RADIUS-Local
Radius authentication is tried first, switching to Local if
unsuccessful.
Local-RADIUS
Authentication is performed locally first, switching to Radius if
unsuccessful
TACACS+
Verify the ID against the external TACACS+ server.
TACACS+-Local
TACACS+ authentication is tried first, switching to Local if
unsuccessful.
Local-TACACS+
Authentication is performed locally first, switching to Radius if
unsuccessful
None
Authentication is not required.
Try next type on authentication denied (default=Disable): The field enables or disables the
system to try next type on first authentication denied.
Disconnect by (default=None): If this field is set as DCD-off, the connection will be disconnected
when the DCD signal is off. If this field is set as DSR-off, the connection will be disconnected
when the DSR signal is off.