Hardware manual

TC-6110 Hardware BIOS Setup
3-14
ATTENTION
We suggest you use a USB drive with under 2 GB
of
disk space, as larger USB drives may not support the FAT
file format and
will consequently fail to boot.
Step 2: Prepare the Upgrade File.
You must use the BIOS upgrade installation file to upgrade the BIOS. You can send your request to Moxa's
technical support team at [e-mail] to get an updated version of the BIOS.
1. Get the BIOS upgrade installation file. The file name should have following format: 6110xxSxx.exe (xx
refers to version numbers)
2. Copy the file to the Bootable USB Disk.
Step 3: Run the upgrade program on the TC-6110 computer
1. Reboot the computer and go to the Boot Manager by pressing F12 while booting up, before the operating
system has begun to load.
2. Select USB Disk as the first boot source. Press Enter to continue.
3. Once the computer boots, a DOS screen will appear. Go to the directory where the upgrade file is located.
For example, if the upgrade file is stored in the TC6110 folder, type:
C:\ cd TC6110
4. Run the upgrade program by typing:
C:\ TC6110>611010S05.exe
Please note that the upgrade filename may vary depending on the firmware version.
5. The upgrade program will run. Wait until the procedure is finished before initiating any changes to the
system. Be patient; the upgrade will take quite a few minutes.
DO NOT ALLOW THE COMPUTER TO POWER DOWN! DO NOT REMOVE THE USB DRIVE!