Hardware manual

TC-6110 Hardware Hardware Installation
2-17
Step 9: Use a small screwdriver or other tool to release the clutches on the battery socket, and remove the old
battery. Gently place the new battery into the socket.
Step 10: When finished, reverse the steps above to rebuild the TC-6110 unit.
Installing System Memory and CF Card
The TC-6110 computer comes with two system memory sockets; one of these is pre-installed with 2 GB of
memory. In addition, an 8 GB CompactFlash card has also been pre-installed. Follow the steps below to add or
replace either the system memory or the CF card.
Refer to Steps 1 through 8 in the section, Replacing the Battery; then follow the steps below.
Step 9: Remove the seven brass standoffs on
the upper main board.
Step 10: Gently remove the upper main board,
and then locate the system memory and CF
socket.