Hardware manual

TC-6110 Hardware Hardware Installation
2-16
Step 6: In addition, you will need to release all hardware interfaces from the front plate of the main interface
module. These are two panel screws, four screws holding the D-Sub connectors in place, and the four rings that
fasten the four M12 connectors in place (audio, USB, and two LAN ports). These are all shown below.
Step 7: Finally, a single screw on either side of the heat sink also needs to be removed.
Step 8: Once all screws have been unfastened, gently push the cover to the left to reveal the battery’s location.