User`s manual

NPort 5600-8-DT User’s Manual Operation Mode Advanced Settings
6-8

Designated local port 1 through 4
Real COM Mode
TCP Server Mode
TCP Client Mode
UDP Mode
Reverse Telnet Mode
Pair Connection Mode
RFC2217 Mode
Range: 1 to 65535
Default: none
Description: This specifies the TCP port number that will be
used for data transmission with the device port.

Local listen port
Real COM Mode
TCP Server Mode
TCP Client Mode
UDP Mode
Reverse Telnet Mode
Pair Connection Mode
RFC2217 Mode
Range: 1 to 65535
Default: 4001 for port 1, 4002 for port 2, etc.
Description: This specifies the UDP port number for network
communication to the serial device. Socket applications will
need to refer to the device using this port number.

Connection Control
Real COM Mode
TCP Server Mode
TCP Client Mode
UDP Mode
Reverse Telnet Mode
Pair Connection Mode
RFC2217 Mode
Range: Startup/None, Any Character/None, Any
Character/Inactivity Time, DSR On/DSR Off, DSR
On/None, DCD On/DCD Off, DCD On/None
Default: Startup/None
Description: This specifies how connections to the device are
established and closed.For example, “Startup/None” means
that as soon as the device server starts up, the TCP
connection is opened, and the connection can only be closed
manually. “DCD On/DCD Off” means that the TCP
connection is opened when the DCD signal is on, and closed
when the DCD signal is off.
If you want to use the Inactivity Time parameter to close the
connection when the serial device is inactive, you must set
Connection Control to “Any Character/Inactivity time”.

Map <CR-LF>
Real COM Mode
TCP Server Mode
TCP Client Mode
UDP Mode
Reverse Telnet Mode
Pair Connection Mode
RFC2217 Mode
Range: CR, LF, or CR-LF
Default: CR-LF
Description: This specifies how CR-LF characters received
from the device will be packed for network transmission.
For certain terminal applications, the Enter key needs to be
translated specifically as a CR character rather than CR-LF.