User`s manual

NPort 5600-8-DT User’s Manual General Settings
4-10
(Data Communication Equipment) is powered on. A DSR change to low indicates that the DCE is
powered off.
ATTENTION
DCD and DSR signal changes are only applicable for the RS-232 interface.
Alarm Audio File
This setting is available in the web console only. Please refer to Chapter 7 for additional
information. The audio file parameter is used to configure the built-in audio alarm. Select a .WAV
file to use as the audio alarm. This file must be a 16-bit uncompressed 48 kHz .WAV audio file no
larger than 511 KB.
Change Password
You can set a password to restrict access to the NPort’s configuration parameters. If a user does
not enter the password, access to the NPort configuration settings will be denied, whether it is
through NPort Administrator or through one of the consoles (e.g., web console). In order to
remove password protection, leave the New password and Retype password parameters blank.
ATTENTION
If you forget the NPort’s password, the ONLY way to configure the NPort is by using the
hardware reset button load the factory defaults.
Before you set a password for the first time, it is a good idea to export the NPort’s completed
configuration to a file. Your configuration can then be easily restored if necessary. For additional
information on configuration management, please refer to Chapter 8.