User`s manual

3
3
Chapter 3Basic Installation
The NPort 5600-8-DT device server is designed to coordinate between your network, your host
computer, and your serial device. Installation of the device server should occur in stages to ensure
that each connection is recognized. This chapter will guide you through a typical installation with
a Windows PC. For certain applications or environments, you may be guided to other chapters for
additional information.
The following topics are covered in this chapter:
 Before You Begin
 STEP 1: Connect network, serial device, and power
¾ Connect to Network
¾ Attach Serial Device
¾ Connect Power
 STEP 2: Configure the device server’s general settings
¾ Install NPort Administrator
¾ Search for Device Server on LAN
¾ Adjust Network Settings
¾ Verify Network Settings
 STEP 3: Configure device port operation mode
¾ Adjust Port Mode Settings
 STEP 4: Configure serial communication parameters
¾ Review Serial Parameters
¾ Adjust Serial Parameters
 STEP 5: Map COM port to device
¾ Specify Target Device Server
¾ Assign COM Port Number to Device Port
¾ Apply Change