User`s manual

NPort 5600-8-DT User’s Manual Overview of Hardware
2-3
Bottom View
Terminator
SW
ON
OFF
1 23
Pull High Pull Low
Default
Termination Resistor for the RS-485 Port
----
DIP switches for pull high/low resistors
DIP switch reference chart
Item Description
PWR LED Indicates power input status (red)
Ready and Fault LEDs Indicates normal operation (green) or IP conflict (red)
Link LED Flashes when Ethernet is connected
InUse LEDs Flashes when device port is transmitting or receiving data
(green)
Device port Tx LEDs Flashes when device port is transmitting data (green)
Device port Rx LEDs Flashes when device port is receiving data (orange)
LCM console display Displays server settings
Input buttons Navigates server settings
Power switch Turns server on and off
Terminal block power input For connection to DC power source
Power input For power jack connection to AC power source here
Ethernet port For Ethernet network cable connection
Device ports (DB9 or RJ45) For attachment of serial devices
RS-232 console port For access to serial console (CPU embedded UART Port 1)
Reset button Press and hold with a pointed object for 5 seconds to load
factory defaults
DIP switches for pull
high/low resistors
Remove cover to adjust pull high/low resistors (150K/1K) on
the NPort 5650-8-DT, 5650-8-DT-J, and 5650I-8-DT
Alarm speakers For audio alarm